Beam clamp type JG RX-lift
Beam clamp type WJC RX-lift
Concrete pipe clamp type PLG RX-lift
• EN 13155
• vertical transportation of concrete pipe sections up to 2 m in diameter
• clamps are used in combination with three-leg sling in sets of three clamps
• total capacity is stated for sets of three clamps
• clams have solid construction and simple manipulation
• for concrete according to DIN 4034
Drum clamp type LQ RX-lift
Drum clamp type LR RX-lift
Drum clamp type TDV RX-lift
Horizontal beam clamp type TMC RX-lift
• EN 13155
• horizontal lifting and transport of beam profiles, plates, sheets and sheet stacks
• use with two-leg sling or spreader beam
• the wide, split lower jaw is particularly suitable for gripping beam profiles & girders (gripping at the ends or on the side of the beam)
• safety lock mechanism in open and close position
• temperature of use form -40 do 100 °C
Select options
This product has multiple variants. The options may be chosen on the product page
Horizontal lifter type PDK RX-lift
• EN 13155
• large opening grips
• use in pairs
• Simple clamping mechanism to adjust the gripper opening
• designed to transfer a larger amount of plates at once
• Do not use at temperatures above 100°C
• Do not lift stainless steel or copper plates
• Use a load-bearing beam / yoke when transporting longer loads
Horizontal lifter type TCH RX-lift
Horizontal lifter, for stainless steel plates and constructions type STS-A RX-lift
• EN 13155
• usage: lift and transport stainless steel plates and structures in a horizontal position
• for safe transport, the gripper surface must be dry, clean and
non-greasy, free of any lubricant or dust
• Do not use on smooth, polished surfaces as they have various
lubricating compounds on them
• must clean the jaw of the gripper regularly in clean water, do not use solvents
• must check the handle before each use, make sure that it is
clean and undamaged, otherwise remove it from use